Reattach the bonnet – you will know it’s securely in place when you feel a snap and hear a ‘click’.If however the key is in place, the bonnet correctly assembled, yet the yellow light flashing still, you may need to: An alternative cause to a faulty bonnet connection may be that the black key on the back of the globe is not in the slot and it’s lifting the bonnet. If the bonnet is not securely placed on, the globe won’t rotate and you’ll find the yellow light blinking. You’ll know everything is back to normal when you see the blue light again. When it’s tight enough and doesn’t move anymore, you can place the globe back on the base, turn on the power and press Cycle.Using your 3mm hex wrench, tighten the screw by turning it to the right.Once aligned, turn off the power and unplug your Litter-Robot.The flat side of the shaft should be facing you. If you don’t see it, you can turn on the power and watch for the flat side to rotate into the position that allows you to actually see the set screw.You will need to locate the shaft that’s attached to the gear – that’s where you can also find the screw and if you can see it straight away you can skip directly to using the wrench.First you will need to unplug the unit, remove the globe and press on the black gear located on the side.In this case, it appears that the set screw has come loose and you will need a 3mm hex wrench to fix it. It may also happen that your unit has a loose or free spinning gear and no globe movement. Litter Robot 3 Has Lights to Indicate issues.ģ. Your Litter-Robot will perform a cycle and return to its Home position with the blue light on. Plug in the power supply and turn the unit back on.Lock the black key on the back of the globe into the pocket. Once you’re done, put the globe and bonnet back in place, ensuring all four tabs are in place as well.You will need to ensure there’s a maximum of 10 pounds of litter or for it to be filled to the line. Be sure to also check if there’s any excessive litter and remove it if the case calls for it.What you need to do next is to inspect if there’s any liquid accumulation or residue right where the globe usually rests, with specific attention to its top portion from the exterior. You will also need to remove the globe, paying attention not to let it roll.In order to reset the unit and have everything functioning alright again, you will first need to remove the bonnet and put it aside.Here’s how to troubleshoot your jammed globe: The Globe can also get jammed at one point or another in time, making the motor stop and the control panel to display a yellow-to-red blinking sequence.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |